Exam 3: Networking

Internet Protocol version 6 (IPv6) has an address size of _________ bits and uses _______ values to indicate addresses

Which of the following commands will display the forward/filter table in a switch?

Which of the following fields make up a switch's bridge ID (BID)?

David is working as a network administrator at his organization. His network is using EIGRP. He wants to check the IP addresses of the adjacent neighbors, and verify the EIGRP retransmit intervals and queue counts. Which of the following commands should he use?

Which of the following RJ-45 cable types is used to connect a PC's COM port to a router or a switch console port?

David is a network administrator at his organization. He must use a routing protocol to connect the two autonomous systems as displayed in the figure. Which protocol should he choose?

Which of the following is not a correctly written IPv6 address?

As a part of a troubleshooting process, John wants to check the table that maintains the TCP/IP to MAC address translation on his computer. Which utility should he use?

Which of the following statements regarding a switch, bridge, or a hub is NOT true?

A PC has been configured with a static IP address of 192.168.1.122. Bill tries to run the ping 127.0.0.1 command on this PC, but he does not receive any reply for this command. What should he infer from this?

Dave is trying to add a new router on an OSPF network. The networks attached to the new router do not appear in the routing tables of the other OSPF routers. The new router's configuration is as follows:Router(config)# router ospf 66Router(config-if)# network 10.0.0.0 255.0.0.0 area 0Which of the following could most likely be the issue?

John enters the show processes command on a router before entering a debug command. Why would he need to enter the show processes command?

The cables that lead from patch panels (in the wall) to computers and are placed above ceiling tiles are called:

What is the default subnet mask for the IP address 192.168.10.10?

Two hosts on a LAN have accidentally transmitted at the same time, resulting in a collision. Which of the following specifies the first step that occurs after a collision takes place?

Dave is a new network consultant and is designing a new network for a small business. Dave discovers that the entire LAN, whose addresses are all 192.168.1.x/24, will need Internet access. What device must Dave install between the LAN and the Internet?

David is a network administrator in his organization. He has configured OSPF on a router with both physical and logical interfaces. Which of the following factors would determine the router ID?

David wants to configure a single router to load balance traffic across 5 unequal cost paths. Which of the following routing protocols can be used?

Which one of the following can significantly increase congestion on an Ethernet network?

Two computers are communicating using a TCP protocol. The receiving host has failed to receive all of the segments that should be acknowledged. Which of the following can the host do to improve the reliability of this communication session?