Deck 7: Introduction to Router Configuration

Question 1

AUI stands for which of the following?

A)Auxiliary unit interface
B)Attachment unit interconnect
C)Auxiliary unity interconnect
D)Attachment unit interface
E)None of these answers are correct.

Answer 1

D

Question 2

Why is it recommended as a best practice to change the name of the default VLAN 1?

A) To prevent malicious access using the default VLAN 1 setting
B) To segregate VLANs based on type or designated group
C) Both a and b
D) None of the above

Answer 2

C

Question 3

The prompt for a router's user EXEC mode is router/ >.

Answer 3

False

Question 4

The values for configuring a serial connection to connect to a Cisco router's console port are:
5600bps
8 data bits
No parity
1 stop bit
Hardware flow control

Question 5

The sequence of commands for setting the enable secret to Chile is:
router> enable
router# enable secret Chile

Question 6

The command line vty 0 4 means:
line places the router in the line configuration mode
vty: virtual terminal
0 4: indicates virtual terminal connections can be simultaneously configured

Question 7

The router commands used to configure and enable the FastEthernet 0/1 router interface with the IP address of 10.10.20.250 and a subnet mask of 255.255.0.0 are:
Router# conf t
Router(config)# int fa0/1
Router(config-if)# ip address 10.10.20.250 255.255.0.0
Router(config-if)# no shut

Question 8

Switches typically operate within which OSI level?

A) Application
B) Network
C) Physical
D) Session

Question 9

The AUI port on a router connects to which networking protocol?

A)100BaseT
B)Token-Ring
C)Ethernet
D)CAT5e
E)None of these answers are correct.

Question 10

The sh ip int brief command shows that the protocol for Ethernet0 is "down" and the status is up.This indicates which of the following?

A)The router interface is not enabled.
B)The routing protocol has not been configured.
C)The router is not communicating with another networking device.
D)None of these answers are correct.

Question 11

On STP-enabled switches,which of the four STP states can be bypassed to speed up the process?

A) The listen and learn states
B) The block and listen states
C) The block and learn states
D) The learn and forward states

Question 12

The DCE end of a V.35 cable is female.

Question 13

The designation s0/0 indicates which of the following?

A)Serial interface zero/zero
B)Ethernet serial interface zero
C)Serial input zero
D)Is not used with Cisco routers

Question 14

What switch information is not available with the show version command?

A) The time of the last system restart
B) The switch's MAC address
C) The current running state of the switch
D) The amount of configuration memory

Question 15

_________ is (are)the name(s)for more advanced switch security.

A) 802.1x
B) Dot1x
C) Both 802.1x and dot1x
D) Neither 802.1x nor dot1x

Question 16

Which of the following is a recommended switch security best practice?

A) Enable all switch ports after the switch firmware has been updated.
B) Disable all switch ports daily and enable each port when requested by users.
C) Reboot switches daily.
D) Disable all unused ports.

Question 17

A switch needs to communicate with an authentication server for which feature to function?

A) Authenticating users to server file permissions
B) Authenticating switch ports to allowable devices
C) Authenticating the switch to the network
D) Authenticating users to allowable applications

Question 18

Which of the following is not an action that can be taken in the event of a port violation?

A) Segment
B) Shut down
C) Restrict
D) Protect