Deck 6: Configuring Basic Switch Management

Question 1

Which command can be used to alter the default display behavior of syslog messages on a device so that they will not interrupt the output of a show command?

A) logging timed
B) synchronize messages
C) logging systematic
D) logging synchronous

Answer 1

logging synchronous

Question 2

What is the name used to identify a virtual NIC type of device that exists on Cisco switches to assign IP information to specific VLANs?

A) SVC
B) PVC
C) VRF
D) SVI

Answer 2

SVI

Question 3

How many VLAN interfaces (SVI) can exist and be up on a typical Layer 2 Cisco switch at the same time?

A) 1
B) 8
C) 2
D) 4096

Answer 3

1

Question 4

Which Cisco IOS command is used to display local interface (not server) DHCP IPv4 assignment information?

A) show ip dhcp lease
B) show dhcp lease
C) show ip dhcp binding
D) show dhcp ip binding

Question 5

Which of the following commands is used to enable console password security using a simple password?

A) line con 0
B) login
C) password password-value
D) line vty 0 15

Question 6

Which of the following commands is used to initiate the configuration mode to set a password for Telnet?

A) line con 0
B) login
C) password password-value
D) line vty 0 15

Question 7

Which of the following commands are shared between the console and Telnet for the setup of simple passwords?

A) line con 0
B) login
C) password password-value
D) line vty 0 15

Question 8

Which of the following is a characteristic of the shared passwords used in networking?

A) The individual user defines each password.
B) Every piece of equipment must use the same password.
C) All configuration modes use the same password.
D) The password is set and known by administrators.

Question 9

Which of the following commands should be used to force the use of username/password combinations stored on the local switch for both the console and Telnet?

A) line con 0
B) username name secret password
C) login local
D) no password

Question 10

Which of the following transport input commands will configure a port to support both Telnet and SSH?

A) transport input all
B) transport input telnet ssh
C) transport input both
D) transport input default

Question 11

Which of the following commands should be done as a precursor to generating a matched public and private key for encryption?

A) hostname name
B) ip domain-name name
C) crypto key prepare rsa
D) ip ssh version 2

Question 12

Which of the following protocols are enabled by default on a Cisco router for external users to access?

A) Telnet
B) SSH
C) Both Telnet and SSH
D) Neither Telnet nor SSH

Question 13

Which of the following commands should immediately follow interface vlan 1 when configuring IPv4 on a switch?

A) ip address ip-address mask
B) no shutdown
C) ip default-gateway ip-address
D) ip name-server ip-address1 ip-address2 …

Question 14

Which of the following commands is used to configure a switch to use DNS to resolve a name to a matching IP address?

A) ip address ip-address mask
B) no shutdown
C) ip default-gateway ip-address
D) ip name-server ip-address1 ip-address2 …

Question 15

Which of the following commands in configuration mode will enable the VLAN interface if it is not already enabled?

A) ip address ip-address mask
B) no shutdown
C) ip default-gateway ip-address
D) ip name-server ip-address1 ip-address2 …