Deck 16: Configuring IPV4 Addresses and Static Routes

Question 1

As the network engineer, you are configuring the Fast Ethernet interface. You have issued the following command to the fa0/0 interface: ip address 200.16.24.1 255.255.255.0. Which of the following must be TRUE before the router can add this information to its routing table?

A) The interface status codes for the interface must be in the Up and Up condition.
B) The interface must be administratively turned off.
C) The interface must have the no shutdown command issued.
D) The router must be able to communicate with its neighbor first.

Answer 1

The interface status codes for the interface must be in the Up and Up condition.
The interface must have the no shutdown command issued.

Question 2

You need to configure a default route. Which of the following commands is the correct way to set the default route out of your network?

A) ip route 0.0.0.0.0.0.0.0 172.20.3.2
B) ip route 0.0.0.0 0.0.0.0 172.20.3.2
C) ip route 0.0.0.0 172.20.3.2
D) ip route any 172.20.3.2

Answer 2

ip route 0.0.0.0 0.0.0.0 172.20.3.2

Question 3

Which conditions must be met for a router to process a frame?

A) The frame isn't marked Discard Eligible.
B) The frame source address is the same as the local address (Layer 2).
C) The frame has no errors.
D) The frame destination address is the same as the local address (Layer 2).

Answer 3

The frame has no errors.
The frame destination address is the same as the local address (Layer 2).

Question 4

What is the process of removing the Layer 2 header and trailer information to reveal the Layer 3 packet?

A) De-encapsulation
B) Encapsulation
C) Encryption
D) Decryption

Question 5

What type of route adds the subnet to the routing table of a Cisco device when the ip address command is issued on an interface with a state of up/up?

A) Local route
B) Connected route
C) Static route
D) Interface route

Question 6

What type of route adds the host to the routing table of a Cisco device when the ip address command is issued on an interface with a state of up/up?

A) Local route
B) Connected route
C) Static route
D) Interface route

Question 7

The ________ configuration creates a subinterface for each VLAN on the trunk and routes all frames associated with each VLAN ID as it comes in or out of the subinterface.

A) MLS
B) CEF
C) ROAS
D) Fast switching

Question 8

When configuring a trunk between a router and a switch, which command must be configured on the switch to ensure that the trunk comes up?

A) switchport mode dynamic desirable
B) switchport mode dynamic auto
C) switchport mode access
D) switchport mode trunk

Question 9

What parameter can be added to the end of a Cisco IOS ip route command to force its inclusion into the routing table, regardless of interface/next-hop status?

A) permanent
B) full
C) Configure the AD to 0
D) Configure the AD to 1

Question 10

The term IP routing refers explicitly to which of the following actions?

A) Learning routes
B) Dynamically establishing routes using IP protocols
C) Forwarding packets
D) Establishing protocols for routes

Question 11

Which of the following is the first step a LAN-based host takes when a destination is NOT local?

A) Find the destination host's MAC address.
B) Encapsulate the IP packet in a data-link frame for the destination host.
C) Find the default gateway's MAC address.
D) Encapsulate the IP packet in a data-link frame for the default gateway.