Exam 24: Dual Dimensioning

The metric unit of measurement most commonly used on dual-dimensioned prints is the ____.

When the ____ method is used, the inch and metric dimensions are placed in specific locations with respect to one another.

Angle dimensions indicated in ____ are common to the inch and metric systems, and, therefore, are not normally shown as dual dimensioned.

The ____________________ is used in cases where dimensions are so large that it is impractical to show or perform the measurement in millimeters.

When working with large dimensions, 18000 millimeters is best shown as ____ meters.

To convert a millimeter dimension to inches, divide it by ____.

It is standard practice to use "____" in a note to indicate diameter.

Dual dimensioning is being used by many manufacturers during the transition period from the U.S. Customary (inch) system of measurement to the metric system.

Dual-dimensioned prints are more costly to prepare; however, they permit greater flexibility in their application.

Manufacturers who market their products to international consumers only use SI dimensioning.

____________________ dimensioning is the use of dimensions in both the U.S. Customary and SI systems of measurement on drawings.

When the ____ method is used, the units are separated either by a horizontal line (usually a dimension line) or a slash line.

The U.S. Customary unit of measurement may be given as a common or decimal fraction, but the common fraction is preferred.

Countries that use the metric system normally prepare drawings using ____ projection.

Through the use of ____ prints, parts that are to be manufactured to metric dimensions may be produced by using machines that are graduated in the inch system of measurement.

The positioning arrangement selected for dual dimensioning is indicated by a(n) ____________________ on the drawing.

In converting an inch value to a millimeter value, it is standard practice to show the millimeter value to one more decimal value than the original inch value.

An alternative to the positioning and bracket methods for dual dimensioning is to provide a(n) ____________________ chart on the print.

Dimensioning a drawing with ____________________ fractions has become standard practice.

The ____ between inch and metric dimensions is determined by the number of decimal places to which each dimension is rounded off.