Question 1

An electric strike will typically operate from_________.

Accepted Answer

A)  3 or 6 V 
B)  6 V 
C)  12 or 24 V 
D)  48 V 
A)  3 or 6 V 
B)  6 V 
C)  12 or 24 V 
D)  48 V C

Question 2

Match between columns
                        Premises: ________ Sound waves bounce off the object and back to the sensor's receiver

Accepted Answer

The Answer of Photoelectric Beam and Active Infrared and Microwave/Radar is...

Question 3

Match between columns
                        Premises: ________ Combine more than one technology in one enclosure

Accepted Answer

The Answer of Ultrasonic and Vibration and Acoustic and Video is...

Question 4

The most important function of a keypad is to ________.

Accepted Answer

A)  Act as an interface between the sensors and the electronic strikes. 
B)  Provide audible alerts for the occupants. 
C)  Sense motion in the general area of the keypad. 
D)  Provide the ability to arm and disarm the alarm. 
A)  Act as an interface between the sensors and the electronic strikes. 
B)  Provide audible alerts for the occupants. 
C)  Sense motion in the general area of the keypad. 
D)  Provide the ability to arm and disarm the alarm.

Question 5

Match between columns
                        Premises: ________ Operates at a very high frequency

Accepted Answer

The Answer of Ultrasonic and Video Motion Detection and Dual-Technology is...

Question 6

The type of sensing device to use in a access control systems typically depends on the layout of the building and the detail in which you need protection.

Accepted Answer

A) True 
 B)False

Question 7

What type of card reader does not require physical contact to occur?

Accepted Answer

A)  Wiegand 
B)  Magstripe 
C)  ATM 
D)  All the above 
A)  Wiegand 
B)  Magstripe 
C)  ATM 
D)  All the above

Question 8

Match between columns
                        Premises: ________ Project pulsed infrared from a transmitter to receiver

Accepted Answer

The Answer of Photoelectric Beam and Active Infrared and Passive is...

Question 9

A good rule with power supplies is to not load them more than _____ of their capacity.

Accepted Answer

A)  50% 
B)  60% 
C)  70% 
D)  100% 
A)  50% 
B)  60% 
C)  70% 
D)  100%

Question 10

What type of battery is used for the battery backup in an access control syste?

Accepted Answer

A)  Sealed battery 
B)  Lead-acid battery 
C)  Gel-type battery 
D)  All the above 
A)  Sealed battery 
B)  Lead-acid battery 
C)  Gel-type battery 
D)  All the above

Question 11

Match between columns
                        Premises: ________ Allow security guards to monitor areas where they do not have to be present

Accepted Answer

The Answer of Microwave/Radar and Video Motion Detection and Dual-Technology is...

Question 12

What size resistor is typically used as an EOL resistor?

Accepted Answer

A)  1000 ohm 
B)  4700 ohm 
C)  6800 ohm 
D)  10 Kohm 
A)  1000 ohm 
B)  4700 ohm 
C)  6800 ohm 
D)  10 Kohm

Question 13

Typically, access control systems only require one power supply.

Accepted Answer

A) True 
 B)False

Question 14

What cable is preferred when wiring a security system?

Accepted Answer

A)  Copper clad aluminum 
B)  18-22 AWG, twisted 2-wire, stranded 
C)  Not smaller than 14 AWG copper 
D)  Any CAT 5 cable 
A)  Copper clad aluminum 
B)  18-22 AWG, twisted 2-wire, stranded 
C)  Not smaller than 14 AWG copper 
D)  Any CAT 5 cable

Question 15

Wiring and cabling for all access control systems must comply with Article 300 of the National Electrical Code.

Accepted Answer

A) True 
 B)False

Question 16

Most access control systems are connected to the buildings network through a CAT 5 cable.

Accepted Answer

A) True 
 B)False

Question 17

Match between columns
                        Premises: ________ Glass break sensor

Accepted Answer

The Answer of Photoelectric Beam and Dual-Technology Motion and Microwave/Radar is...

Question 18

Maglocks are always fail-secure.

Accepted Answer

A) True 
 B)False

Question 19

Match between columns
                        Premises: ________ Must be a direct path from Transmitter to receiver

Accepted Answer

The Answer of Acoustic and Vibration and Video Motion Detection is...

Question 20

The primary function of an access control system is to ______.

Accepted Answer

A)  Protect valuables 
B)  Limit access to a desired location 
C)  Secure the perimeter 
D)  All the above 
A)  Protect valuables 
B)  Limit access to a desired location 
C)  Secure the perimeter 
D)  All the above

An electric strike will typically operate from_________.

The most important function of a keypad is to ________.

The type of sensing device to use in a access control systems typically depends on the layout of the building and the detail in which you need protection.

What type of card reader does not require physical contact to occur?

A good rule with power supplies is to not load them more than _____ of their capacity.

What type of battery is used for the battery backup in an access control syste?

What size resistor is typically used as an EOL resistor?

Typically, access control systems only require one power supply.

What cable is preferred when wiring a security system?

Wiring and cabling for all access control systems must comply with Article 300 of the National Electrical Code.

Most access control systems are connected to the buildings network through a CAT 5 cable.

Maglocks are always fail-secure.

The primary function of an access control system is to ______.

Introduction to the National Electrical Code

Electrical Conductors and Cable

Grounding and Bonding and the 2011 National Electrical Code, Articles 250, 800, 810, and 820

Audio Physics

Audio Signal-Processing, Amplification, and Reproduction Equipment and National Electrical Code Article 640

Networking and Information Technology Equipment

Power Supplies, Batteries, and Emergency Systems

Article 725 of the National Electrical Code; Classification of Circuits

Fire Alarm Systems and National Electrical Code Article 760

Fiber-Optic Cable and National Electrical Code Article 770

Telecommunications, and National Electrical Code Article 800

Wireless Communications and National Electrical Code Article 810

Close Circuit Television Camera Systems and National Electrical Code Article 820

Filters

Exam 12: Security and Card Access System Basics

An electric strike will typically operate from_________.

The most important function of a keypad is to ________.

The type of sensing device to use in a access control systems typically depends on the layout of the building and the detail in which you need protection.

What type of card reader does not require physical contact to occur?

A good rule with power supplies is to not load them more than _____ of their capacity.

What type of battery is used for the battery backup in an access control syste?

What size resistor is typically used as an EOL resistor?

Typically, access control systems only require one power supply.

What cable is preferred when wiring a security system?

Wiring and cabling for all access control systems must comply with Article 300 of the National Electrical Code.

Most access control systems are connected to the buildings network through a CAT 5 cable.

Maglocks are always fail-secure.

The primary function of an access control system is to ______.

Introduction to the National Electrical Code

Electrical Conductors and Cable

Grounding and Bonding and the 2011 National Electrical Code, Articles 250, 800, 810, and 820

Audio Physics

Audio Signal-Processing, Amplification, and Reproduction Equipment and National Electrical Code Article 640

Networking and Information Technology Equipment

Power Supplies, Batteries, and Emergency Systems

Article 725 of the National Electrical Code; Classification of Circuits

Fire Alarm Systems and National Electrical Code Article 760

Fiber-Optic Cable and National Electrical Code Article 770

Telecommunications, and National Electrical Code Article 800

Wireless Communications and National Electrical Code Article 810

Close Circuit Television Camera Systems and National Electrical Code Article 820

Filters