Exam 14: Radio Frequency and Infotainment Systemsservicing Radio Frequency and Infotainment Systems
Exam 1: Introduction to Automotive Electrical and Electronic Systems Safety90 Questions
Exam 2: Basic Theoriesspecial Tools and Procedures90 Questions
Exam 3: Electrical and Electronic Componentsbasic Electrical Troubleshooting and Service60 Questions
Exam 4: Wiring and Circuit Diagramswiring Repair and Reading Circuit Diagrams60 Questions
Exam 5: Automotive Batteriesbattery Diagnosis and Service60 Questions
Exam 6: Starting Systems and Motor Designsstarting System Diagnosis and Service60 Questions
Exam 7: Charging Systemscharging System Testing and Service61 Questions
Exam 8: Introduction to the Body Computerbody Computer System Diagnosis60 Questions
Exam 9: Computer Inputssensor Diagnostic Routines60 Questions
Exam 10: Vehicle Communication Networksvehicle Multiplexing Diagnostics61 Questions
Exam 11: Lighting Circuitslighting Circuits Repair and Diagnosis65 Questions
Exam 12: Instrumentation and Warning Lampsinstrumentation and Warning Lamp System Diagnosis and Repair60 Questions
Exam 13: Accessorieselectrical Accessories Diagnosis and Repair60 Questions
Exam 14: Radio Frequency and Infotainment Systemsservicing Radio Frequency and Infotainment Systems60 Questions
Exam 15: Passive Restraint and Vehicle Safety Systemsservicing Passive Restraint and Vehicle Safety Systems60 Questions
Exam 16: Vehicles With Alternative Power Sourceshybrid and High-Voltage System Service61 Questions
Select questions type
Technician A says that most immobilizer systems have a method for the customer to add vehicles keys. Technician B says if only one key is available, it can be used twice in order to enter the programming mode. Who is correct?
(Multiple Choice)
4.8/5
(39)
Infotainment refers to a type of ____ system that provides a combination of information and entertainment.
(Multiple Choice)
4.8/5
(35)
The MEMS gyro sensor informs the navigation system of the speed and direction of the vehicle.
(True/False)
4.8/5
(36)
The TPS internal transmitter broadcasts tire pressure and ____ information to a dedicated electronic control unit (ECU).
(Multiple Choice)
4.8/5
(32)
The radio choke is installed in the antenna output circuit to prevent unwanted and random signals from reaching the radio.
(True/False)
4.9/5
(43)
The ____ acts as an electronic switch to change between the different audio sources.
(Multiple Choice)
4.9/5
(32)
Radiated noise results from an accessory that produces a signal that is detected by ____.
(Multiple Choice)
4.8/5
(39)
The keyless engine starting function can be performed only if the antenna determines that
the transmitter is within the vehicle.
(True/False)
4.8/5
(34)
Most tire pressure monitoring systems use a(n) ____ sensor transmitter in each wheel.
(Multiple Choice)
4.9/5
(40)
What technology is used to provide hands-free cellphone service?
(Short Answer)
4.9/5
(42)
A customer is concerned that the navigation system does not seem to indicate the location of the vehicle properly. This is an intermittent condition. Technician A says the system may be using dead reckoning. Technician B says the system may have lost its have lost the satellite signal. Who is correct?
(Multiple Choice)
4.9/5
(42)
Tire pressure sensors are attached to the rim by a sleeve nut on the ____.
(Multiple Choice)
4.8/5
(29)
What is the most common cause for telematics connectivity issues?
(Short Answer)
4.9/5
(38)
Most of today's audio/video systems can be diagnosed with a(n) ____ since the system will set fault codes when a failure is determined.
(Multiple Choice)
4.9/5
(35)
The immobilizer ____ is either mounted to the steering column or in the instrument panel.
(Multiple Choice)
4.9/5
(51)
Technician A says the multiplexer is used to a switch to allow the antenna and the rear heater grid to use the same circuits. Technician B says Wi-Fi wireless internet connection can be used to create a Hotspot in the vehicle. Who is correct?
(Multiple Choice)
4.9/5
(37)
Technician A says a rear window defogger/antenna module separates the RF signal used by the radio from the electrical current used by the grid. Technician B says usually the top grid lines of the heater grid are unheated and used to receive the AM signals. Who is correct?
(Multiple Choice)
4.8/5
(25)
The PIN code requires a different signal every transmission to improve security.
(True/False)
4.7/5
(40)
Showing 41 - 60 of 60
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)