Exam 15: Passive Restraint and Vehicle Safety Systemsservicing Passive Restraint and Vehicle Safety Systems
Exam 1: Introduction to Automotive Electrical and Electronic Systems Safety90 Questions
Exam 2: Basic Theoriesspecial Tools and Procedures90 Questions
Exam 3: Electrical and Electronic Componentsbasic Electrical Troubleshooting and Service60 Questions
Exam 4: Wiring and Circuit Diagramswiring Repair and Reading Circuit Diagrams60 Questions
Exam 5: Automotive Batteriesbattery Diagnosis and Service60 Questions
Exam 6: Starting Systems and Motor Designsstarting System Diagnosis and Service60 Questions
Exam 7: Charging Systemscharging System Testing and Service61 Questions
Exam 8: Introduction to the Body Computerbody Computer System Diagnosis60 Questions
Exam 9: Computer Inputssensor Diagnostic Routines60 Questions
Exam 10: Vehicle Communication Networksvehicle Multiplexing Diagnostics61 Questions
Exam 11: Lighting Circuitslighting Circuits Repair and Diagnosis65 Questions
Exam 12: Instrumentation and Warning Lampsinstrumentation and Warning Lamp System Diagnosis and Repair60 Questions
Exam 13: Accessorieselectrical Accessories Diagnosis and Repair60 Questions
Exam 14: Radio Frequency and Infotainment Systemsservicing Radio Frequency and Infotainment Systems60 Questions
Exam 15: Passive Restraint and Vehicle Safety Systemsservicing Passive Restraint and Vehicle Safety Systems60 Questions
Exam 16: Vehicles With Alternative Power Sourceshybrid and High-Voltage System Service61 Questions
Select questions type
Which of the following tools should NOT be used to test an air bag system?
(Multiple Choice)
4.9/5
(40)
How does the lane departure system determine if the vehicle is wondering?
(Essay)
4.9/5
(31)
Most automotive manufacturers, and many after-market suppliers, developed a method of performing air bag diagnostics by use of an air bag _____.
(Multiple Choice)
4.8/5
(49)
The diagnostic system check involves observing the air bag ____ to determine if it is operating normally.
(Multiple Choice)
4.8/5
(42)
What do most lane departure warning system use to monitor road features?
(Short Answer)
4.8/5
(38)
Technician A says during a frontal collision, the backup power supply will deploy the air bag if the battery becomes disconnected. Technician B says all backup power supplies will power down one minute after the negative battery is disconnected. Who is correct?
(Multiple Choice)
4.8/5
(40)
All of the following are types of hybrid air bag modules EXCEPT
(Multiple Choice)
4.9/5
(32)
Always disconnect the negative battery cable and wait the recommended time before attempting any service on an air bag system.
(True/False)
4.8/5
(29)
Because the rollover mitigation system ties to the ESP system, diagnostics of the actuators are based on ABS diagnostic routines.
(True/False)
4.9/5
(45)
An undeployed air bag is being replaced because the trim cover is cut. Technician A says it can be recovered. Technician B says it must be deployed before it is scrapped. Who is right?
(Multiple Choice)
4.9/5
(32)
Technician A says that the occupant restraint controller is responsible for deploying the air bag. Technician B says that some the occupant restraint controller can shut the system off. Who is correct?
(Multiple Choice)
4.9/5
(41)
Technician A says if the battery is disconnected, the steering angle sensor may require initialization before the parking system will operate. Technician B says testing of all of the detection range of the sensors of the automatic parking system requires the transmission to be in REVERSE Who is correct?
(Multiple Choice)
4.8/5
(43)
The side impact air bags deploy at the same time as the front air bags.
(True/False)
4.9/5
(35)
Any time the vehicle is involved in an accident, even if the air bag was not deployed, all air bag system components should be inspected. Service is by ____.
(Multiple Choice)
4.8/5
(42)
What type of safety equipment must be worn when handling a deployed air bag module?
(Short Answer)
4.7/5
(31)
The lane departure warning system camera is capable of detecting white lines, yellow lines, or dots in the road and to track the road features.
(True/False)
4.9/5
(30)
A technician is working under the instrument panel and comes across a yellow connector. What does this mean?
(Multiple Choice)
4.8/5
(45)
Showing 41 - 60 of 60
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)