Exam 3: Job Planning, Benchwork, and Layout

____ tolerances are used to check for runout of diameters related to a center axis, another diameter, or perpendicular surface.

If the tap is somewhat intact, a tap ____ may be used to remove a broken tap.

A ____ wrench has a hooked arm that fits into fasteners with slots..

The ____ wrench is a versatile tool but must be properly adjusted to fit the fastener snugly in order to avoid damage to equipment and injury to you.

____ are brushes used to clean files.

____ wrenches are made with a socket shaped like a box-end wrench in a hollow cylinder on one end and a square hole for attachment to a handle in the other end.

A ____ tolerance allows a dimension to vary either above or below basic size, but not both.

A ____ is a round disc of heavy paper surrounding the center area of a grinding wheel.

____ blades can be run at higher speeds than carbon steel blades.

____ wrenches are used when more torque must be applied to the fastener.

____ blades are the least expensive type of blade, but must be run at slower speeds than blades made of harder materials.

The ____ hacksaw's cutting action is achieved by drawing a saw blade back and forth across a workpiece.

The ____ is the angle of the saw tooth's cutting face.

A ____ test is performed by suspending the wheel through its hole on a finger or other object and then tapping it lightly with something dense but nonmetallic such as a screwdriver handle.

The____ saw is common in almost every shop and is a very useful piece of equipment and gets its name from the fact that the blade is in a vertical orientation supported by two wheels.

____ tolerances are used to specify the location of features related to other features.

____ lines are thin and are broken into alternating long and short dashes.

_____ is when a feature contains the most workpiece material within its tolerance.

A(n) ____ is a plane from which dimensions are referenced.

Blade ____ is the spacing of teeth from one tooth to the next.