Exam 12: Fillet Welds

Intermittent welding consists of a series of ____ welds.

The size of a fillet weld refers to the length of the ____ of the weld.

Extension and ____ lines are occasionally used with the welding symbol to locate the desired welds.

Only the fillet weld symbol may be used in combination with other symbols.

Each short weld in intermittent welding is called a(n) ____.

When the ____ symbol is used, a length dimension is not needed.

If the length of the weld is specified, it is placed on the immediate left of the weld symbol.

In a fillet weld symbol, the two legs are assumed to be equal in size unless otherwise specified.

The center-to-center distance, in inches or millimeters of each increment, is the ____.

____________________ intermittent welding means that the welds appear directly opposite each other on the two sides of the joint.

If the fillet weld symbol has unequal legs, the size of each leg is indicated in ____ at the left of the weld symbol.

The ____ weld is one of the most widely used types of welds.

When a general note covers the size of fillet welds, the dimension does not usually appear on the welding symbol.

Fillet welds must always have equal legs.

Specific lengths of fillet welds can be described by placing the symbols in conjunction with the ____ lines of the drawing.

If a fillet is shown on both sides of the joint, it is identified as a(n) ____________________ fillet weld.

When a length is not specified on the welding symbol, the fillet weld is assumed to be ____________________.

____ lines are used as terminal points for the section lining.

A(n) ____________________ represents length of weld.

The fillet wield symbol is always drawn so that the ____________________ leg is to the reader's left.