Question 1

The viscous friction co-efficient, in force-voltage analogy, is analogous to

Accepted Answer

A) charge 
B) resistance 
C) reciprocal of inductance 
D) reciprocal of conductance 
A) charge 
B) resistance 
C) reciprocal of inductance 
D) reciprocal of conductance

Question 2

signal will become zero when the feedback signal and reference signs are equal.

Accepted Answer

A) Input 
B) Actuating 
C) Feedback 
D) Reference 
A) Input 
B) Actuating 
C) Feedback 
D) Reference

Question 3

The band width, in a feedback amplifier.

Accepted Answer

A) remains unaffected 
B) decreases by the same amount as the gain increase 
C) increases by the sane saaaajajt as the gain decrease 
D) decreases by the same amount as the gain decrease 
A) remains unaffected 
B) decreases by the same amount as the gain increase 
C) increases by the sane saaaajajt as the gain decrease 
D) decreases by the same amount as the gain decrease

Question 4

Due to which of the following reasons excessive bond width in control systems should be avoided ?

Accepted Answer

A) It leads to slow speed of response 
B) It leads to low relative stability 
C) Noise is proportional to band width 
D) None of the above 
A) It leads to slow speed of response 
B) It leads to low relative stability 
C) Noise is proportional to band width 
D) None of the above

Question 5

In electrical-pneumatic system analogy the current is considered analogous to

Accepted Answer

A) velocity 
B) pressure 
C) air flow 
D) air flow rate 
A) velocity 
B) pressure 
C) air flow 
D) air flow rate

The viscous friction co-efficient, in force-voltage analogy, is analogous to

signal will become zero when the feedback signal and reference signs are equal.

The band width, in a feedback amplifier.

Due to which of the following reasons excessive bond width in control systems should be avoided ?

In electrical-pneumatic system analogy the current is considered analogous to

Control Systems and Feedback Loops: Understanding Open and Closed Loop Systems

Control Systems

Control System Components and Functions

Filters

Exam 2: Control Systems and Analogy Analogies

The viscous friction co-efficient, in force-voltage analogy, is analogous to

signal will become zero when the feedback signal and reference signs are equal.

The band width, in a feedback amplifier.

Due to which of the following reasons excessive bond width in control systems should be avoided ?

In electrical-pneumatic system analogy the current is considered analogous to

Control Systems and Feedback Loops: Understanding Open and Closed Loop Systems

Control Systems

Control System Components and Functions

Filters