Exam 27: Printers and Multifunction Devices

During the laser printer process, after the erase lamp exposes the entire surface of the photosensitive drum to light, what happens to the photosensitive coating?

A laser is used to write a(n) ______________ image onto the surface of the drum.

The toner in a laser printer is a fine powder.This powder is made up of plastic particles bonded to _______________ particles.

When discussing laser printers, what does the term photoconductive mean?

When a laser printer's ______________ is charged with an extremely high voltage, an electric field forms, enabling voltage to pass to the drum and charge the photosensitive particles on its surface.

In a laser printer, the pressure roller and heated roller are used to _______________.

If you attempt to use a printer shared by another PC, but Windows pops up with an "Access Denied" error, you might not have ______________ to use the printer.

What element is heated by tiny resistors or electroconductive plates at the end of each tube in an inkjet printer?

What could cause an odd line to be printed down the middle of every page of laser output?

The Add Printer Wizard allows you to set up a local or ______________ printer.

Most printers, scanner, and multifunction devices connect to a computer via a _______________.

You are printing from a dot-matrix printer and notice that the characters look chopped off at the top.What should you try adjusting?

Paper is not feeding properly through an inkjet printer.What's a likely reason?

The term sublimation means to cause something to change from a solid into a _______________ form and then back into a solid.

List the two kinds of thermal printer.

A laser printer creates an image of dots and holds it in memory before printing it.What is this image of dots called?

Assuming a printer is in good working order and online, what should you check next if nothing prints?

Today, the typical ______________ printer uses a standard RJ-45 Ethernet cable or wireless interface.

What removes the paper's positive charge during the fusing stage of the laser printing process?

What are printwires in dot-matrix printers?