Question 1

Why is the length of tag lines limited when used with helicopters?

Accepted Answer

to prevent

Question 2

The greatest angle above the horizontal plane at which a material will lie without sliding is called the

Accepted Answer

A) angle of repose 
B) angle of declination 
C) failsafe angle 
D) none of the above 
A) angle of repose 
B) angle of declination 
C) failsafe angle 
D) none of the above

Question 3

Hydraulic fluids used in aerial lifts around energized lines are required to be of the insulating type.

Accepted Answer

A) True 
 B)False

Question 4

What is the name of the knot shown in the diagram?

Accepted Answer

triple rol

Question 5

Required crane clearances from power lines is less during transit than during crane operation.

Accepted Answer

A) True 
 B)False

Question 6

ROPS are an acceptable alternative to seat belts.

Accepted Answer

A) True 
 B)False

Question 7

The general construction area minimum lighting standard is

Accepted Answer

A) 5 foot-candles 
B) 10 foot-candles 
C) 15 foot-candles 
D) none;there is no general lighting standard for construction sites 
A) 5 foot-candles 
B) 10 foot-candles 
C) 15 foot-candles 
D) none;there is no general lighting standard for construction sites

Question 8

What is the hazard of using concrete blocks for "cribbing?"

Accepted Answer

The answer of What is the hazard of using concrete...

Question 9

What is the acceptable alternative to insetting the cleats on job-made ladders?

Accepted Answer

Use filler blocks be

Question 10

A good grounding conductor can provide protection similar to the GFCI.

Accepted Answer

A) True 
 B)False

Question 11

Which of the following is not a hazard when helicopters are used for lifting?

Accepted Answer

A) cargo hook will not release 
B) filler blocks not used 
C) fire on the ground 
D) static electricity 
A) cargo hook will not release 
B) filler blocks not used 
C) fire on the ground 
D) static electricity

Question 12

Which of the following is a hazard of pneumatics over hydraulics?

Accepted Answer

A) high pressure 
B) electrical conductivity 
C) fire 
D) noise 
A) high pressure 
B) electrical conductivity 
C) fire 
D) noise

Question 13

Which of the following is not a type of scaffold?

Accepted Answer

A) window-jack scaffold 
B) outrigger scaffold 
C) bowstay scaffold 
D) chicken ladder 
A) window-jack scaffold 
B) outrigger scaffold 
C) bowstay scaffold 
D) chicken ladder

Question 14

Powder-actuated tool cartridges are available only in a single power rating.

Accepted Answer

A) True 
 B)False

Question 15

The device pictured is best characterized as a

Accepted Answer

A) check valve 
B) spring-loaded cut-off valve 
C) pressure regulator 
D) coupling
  
A) check valve 
B) spring-loaded cut-off valve 
C) pressure regulator 
D) coupling

Question 16

During structural steel assembly,the use of 1/2 inch wire rope approximately 42 inches high is permitted in lieu of standard guardrails.

Accepted Answer

A) True 
 B)False

Question 17

The greatest concern for construction workers' eyes is for exposure to lasers.

Accepted Answer

A) True 
 B)False

Question 18

Which of the following indicates the heaviest powder charge?

Accepted Answer

A) brass with purple 
B) nickel with gray 
C) nickel with purple 
D) nickel with red 
A) brass with purple 
B) nickel with gray 
C) nickel with purple 
D) nickel with red

Question 19

The biggest problem with fire prevention during construction is the hazard of waste lumber fires.

Accepted Answer

A) True 
 B)False

Question 20

Safety belts and lifelines for personnel on suspended swinging scaffolds must be tied to the building,not to the scaffold.

Accepted Answer

A) True 
 B)False

Why is the length of tag lines limited when used with helicopters?

The greatest angle above the horizontal plane at which a material will lie without sliding is called the

Hydraulic fluids used in aerial lifts around energized lines are required to be of the insulating type.

What is the name of the knot shown in the diagram?

Required crane clearances from power lines is less during transit than during crane operation.

ROPS are an acceptable alternative to seat belts.

The general construction area minimum lighting standard is

What is the hazard of using concrete blocks for "cribbing?"

What is the acceptable alternative to insetting the cleats on job-made ladders?

A good grounding conductor can provide protection similar to the GFCI.

Which of the following is not a hazard when helicopters are used for lifting?

Which of the following is a hazard of pneumatics over hydraulics?

Which of the following is not a type of scaffold?

Powder-actuated tool cartridges are available only in a single power rating.

The device pictured is best characterized as a

During structural steel assembly,the use of 1/2 inch wire rope approximately 42 inches high is permitted in lieu of standard guardrails.

The greatest concern for construction workers' eyes is for exposure to lasers.

Which of the following indicates the heaviest powder charge?

The biggest problem with fire prevention during construction is the hazard of waste lumber fires.

Safety belts and lifelines for personnel on suspended swinging scaffolds must be tied to the building,not to the scaffold.

The Safety and Health Manager

Development of the Safety and Health Function

Concepts of Hazard Avoidance

Impact of Federal Regulation

Information Systems

Process Safety and Disaster Preparedness

Buildings and Facilities

Ergonomics

Health and Toxic Substances

Environmental Control and Noise

Flammable and Explosive Materials

Personal Protection and First Aid

Fire Protection

Materials Handling and Storage

Machine Guarding

Welding

Electrical Hazards

Filters

Exam 18: Construction

Why is the length of tag lines limited when used with helicopters?

The greatest angle above the horizontal plane at which a material will lie without sliding is called the

Hydraulic fluids used in aerial lifts around energized lines are required to be of the insulating type.

What is the name of the knot shown in the diagram?

Required crane clearances from power lines is less during transit than during crane operation.

ROPS are an acceptable alternative to seat belts.

The general construction area minimum lighting standard is

What is the hazard of using concrete blocks for "cribbing?"

What is the acceptable alternative to insetting the cleats on job-made ladders?

A good grounding conductor can provide protection similar to the GFCI.

Which of the following is not a hazard when helicopters are used for lifting?

Which of the following is a hazard of pneumatics over hydraulics?

Which of the following is not a type of scaffold?

Powder-actuated tool cartridges are available only in a single power rating.

The device pictured is best characterized as a

During structural steel assembly,the use of 1/2 inch wire rope approximately 42 inches high is permitted in lieu of standard guardrails.

The greatest concern for construction workers' eyes is for exposure to lasers.

Which of the following indicates the heaviest powder charge?

The biggest problem with fire prevention during construction is the hazard of waste lumber fires.

Safety belts and lifelines for personnel on suspended swinging scaffolds must be tied to the building,not to the scaffold.

The Safety and Health Manager

Development of the Safety and Health Function

Concepts of Hazard Avoidance

Impact of Federal Regulation

Information Systems

Process Safety and Disaster Preparedness

Buildings and Facilities

Ergonomics

Health and Toxic Substances

Environmental Control and Noise

Flammable and Explosive Materials

Personal Protection and First Aid

Fire Protection

Materials Handling and Storage

Machine Guarding

Welding

Electrical Hazards

Filters