Multiple Choice
When using a DMM in resistance mode across terminals Cand D on a 9-pin J1939 receptacle,40 ohms is displayed on the meter.Which of the following is most likely?
A) One missing terminating resistor
B) Both terminating resistors missing
C) Three terminating resistors on the bus
D) The bus is down
Correct Answer:
Verified
Correct Answer:
Verified
Q41: What is the source address (SA)of the
Q42: Technician A says that an Allison TC10
Q43: When does an Allision WT transmission use
Q44: When Allison WT drop-box output is split
Q45: How many ranges are overdrive ratios in
Q47: Which of the following statements accurately describe
Q48: Which of the following are serial communications
Q49: After the maximum number of codes are
Q50: In the event of a total loss
Q51: When ordering parts for any WT transmission,what