Multiple Choice
Before servicing the rear U-joint, slip joint, or center bearing on a two-piece drive shaft, ______.
A) make index marks on both ends of the driveshaft
B) measure the pinion shaft angle
C) measure the distance between the center bearing and slip joint
D) all answers are correct
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q4: Both CV joints on a half shaft
Q11: What is meant by U-joint phasing?
Q22: Technician A says limited slip differential clutch
Q33: Technician A uses an oxyacetylene torch to
Q41: A vehicle with a leaking extension housing
Q67: Limited-slip axles require a special friction modifier
Q70: Both CV joints on a half shaft
Q71: What parts are included in a typical
Q81: Which CV joint test should be performed
Q104: Technician A says FWD axle shafts can