Multiple Choice
This feature control specifies that all points on a surface must be an equal distance from a datum.
A) perpendicularity
B) concentricity
C) parallelism
D) angularity
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q18: The tolerance zone for flatness lies on
Q19: A modifier symbol is enclosed with a:<br>A)square<br>B)circle<br>C)
Q20: Tolerancing means setting acceptable limits of deviation.
Q21: A tangent plane modifier would not include
Q22: The need to tolerance more than just
Q24: This feature control is normally used for
Q25: The concept that some parts vary in
Q26: Rule #1 states: "Where only a tolerance
Q27: This type of tolerance is used for
Q28: To indicate that a specified tolerance applies