Multiple Choice
A leakage problem can occur when connecting an output module to a high-impedance load. This problem can be corrected by connecting:
A) a bleeder resistor in series with the load.
B) a bleeder resistor in parallel with the load.
C) an NO contact in series with the load.
D) an NC contact in parallel with the load.
Correct Answer:
Verified
Correct Answer:
Verified
Q30: PLCs are placed within an enclosure to
Q31: When a PLC is placed in the
Q32: If the scan time is too long,
Q33: The force instructions:<br>A)will force data table bits
Q34: When a grounding connection must be made
Q36: The suppression circuit shown: <img src="https://d2lvgg3v3hfg70.cloudfront.net/TB6812/.jpg" alt="The
Q37: PLCs are generally placed within an enclosure.
Q38: PLC malfunctions due to electrical noise usually
Q39: The suppression device is normally wired in
Q40: Which of the choices of the troubleshooting