Multiple Choice
The shop manual should have a picture of the head bolt tightening sequence. However, if there is no shop manual or technical data available, what would the best tightening sequence be?
A) Go from left to right all of the top row (intake side) first, then tighten all of the bottom row (exhaust) bolts right to left
B) Go from left to right all of the bottom row bolts (exhaust side) first, then tighten all of the top row (intake) bolts right to left
C) Go in a circular pattern beginning in the center and ending on the outboard ends
D) Go in a circular pattern working from the outside toward the center
Correct Answer:
Verified
Correct Answer:
Verified
Q17: A gasket installed upside down or reversed
Q18: Gasket material must be able to seal
Q19: What type of gasket is used on
Q20: What is the major difference between aerobic
Q21: What keeps the cylinder head and block
Q23: Technician A says some seals are designed
Q24: Technician A says cork gaskets are used
Q25: Molded rubber gaskets should be coated with
Q26: After the break-in period, the cylinder head
Q27: After the combustion of the air/fuel mixture,