Multiple Choice
Before servicing the rear U-joint, slip joint, or center bearing on a two-piece drive shaft, ______.
A) make index marks on both ends of the driveshaft
B) measure the pinion shaft angle
C) measure the distance between the center bearing and the slip joint
D) All the answers are correct.
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q78: The double-offset joint is typically used in
Q79: Adjusting _ sets the depth of the
Q80: A popping or clicking noise on turns
Q81: Which CV joint test should be performed
Q82: Axle shafts with CV joints at each
Q84: Technician A says a hunting gearset is
Q85: Technician A uses an impact wrench to
Q86: The three basic types of driving axle
Q87: Plunge-type CV joints allow the length of
Q88: Constant velocity joints are used to transfer