Multiple Choice
A taper can be specified on a drawing:
A) In degrees of taper
B) As a taper ratio
C) By notation that a standard industrial taper is required
D) By any of the ways described in a, b, and c above
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q1: Chamfered edges are usually cut at angles
Q2: The most common standard tapers used in
Q3: If the large diameter of a 10-inch
Q4: A chamfer is an angle cut on
Q5: The rate of increase or decrease of
Q6: Flat taper may be specified as:<br>A)flat taper
Q7: Tapers may be conical or flat.
Q9: Chamfers remove sharp edges, add to the
Q10: The rate of taper can be determined