Multiple Choice
Which of the following is true of system planning regarding parts design?
A) The robot's arm can reach any place accessible to the welder.
B) Mockups and CAD/CAM can be used after the robot is installed to reduce problems.
C) The parts design should consider the lower heat input from automated processes.
D) When possible, all welds should be performed in the flat position.
Correct Answer:
Verified
Correct Answer:
Verified
Q24: The early industrial robots were mainly _
Q25: _ technology can help in selecting materials,
Q26: Movement along the y-axis is also referred
Q27: _ should be mounted around the floor
Q28: In a(n) _ process, the welder controls
Q30: In the 1990s, welding robots could cost
Q31: Movement along the z-axis is also referred
Q32: The rate of travel or speed at
Q33: A signal from the _ indicates that
Q34: A(n) _ is a reprogrammable, multifunctional manipulator