Multiple Choice
To fully enable Dynamic Dispatcher on a Security Gateway:
A) run fw ctl multik set_mode 9 in Expert mode and then reboot
B) Using cpconfig, update the Dynamic Dispatcher value to "full" under the CoreXL menu
C) Edit /proc/interrupts to include multik set_mode 1 at the bottom of the file, save, and reboot
D) run fw ctl multik set_mode 1 in Expert mode and then reboot
Correct Answer:
Verified
Correct Answer:
Verified
Q354: Fill in the blank: In Security Gateways
Q355: What are the steps to configure the
Q356: Which icon indicates that read/write access is
Q357: What is UserCheck?<br>A) Messaging tool used to
Q358: Which of the following commands is used
Q360: At what point is the Internal Certificate
Q361: Bob and Joe both have Administrator Roles
Q362: Which of the following is NOT a
Q363: The security Gateway is installed on GAiA
Q364: To view statistics on detected threats, which