Multiple Choice
After the initial installation on Check Point appliance, you notice that the Management interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24 and default gateway to 192.168.80.1.
A) set interface Mgmt ipv4-address 192.168.80.200 mask-length 24 set static-route default nexthop gateway address 192.168.80.1 on save config
B) add interface Mgmt ipv4-address 192.168.80.200 255.255.255.0 add static-route 0.0.0.0.0.0.0.0 gw 192.168.80.1 on
C) set interface Mgmt ipv4-address 192.168.80.200 255.255.255.0
D) add interface Mgmt ipv4-address 192.168.80.200 mask-length 24 add static-route default nexthop gateway address 192.168.80.1 on
Correct Answer:
Verified
Correct Answer:
Verified
Q532: According to Check Point Best Practice, when
Q533: Which of the following statements is TRUE
Q534: How would you deploy TE250X Check Point
Q535: Which is the correct order of a
Q536: Which Check Point feature enables application scanning
Q538: You are about to integrate RSA SecurID
Q539: Administrator wishes to update IPS from SmartConsole
Q540: With which command can you view the
Q541: On the following picture an administrator configures
Q542: Fill in the blank: A _ is