Multiple Choice
The implementations group has been using the test bed to do a 'proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address. Use the supported commands to isolated the cause of this fault and answer the following questions. What is the solution to the fault condition?
A) In Configuration mode, using the interface port-channel 13 command, then configure switchport trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.
B) In Configuration mode, using the interface port-channel 13, port-channel 23, then configure switchport trunk none allowed vlan none followed by switchport trunk allowed vlan 10,200 commands.
C) In Configuration mode, using the interface port-channel 23 command, then configure switchport trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.
D) In Configuration mode, using the interface port-channel 23, port-channel, then configure switchport trunk allowed vlan none followed by switchport trunk allowed vlan 10,20,200 commands.
Correct Answer:

Verified
Correct Answer:
Verified
Q61: R2 has a locally originated prefix 192.168.130.0/24
Q62: Refer to the exhibit. What does the
Q63: An engineer is troubleshooting on the console
Q64: <img src="https://d2lvgg3v3hfg70.cloudfront.net/C1178/.jpg" alt=" Refer to the
Q65: Refer to the exhibit. An administrator noticed
Q67: Which protocol is used to determine the
Q68: A DMVPN single hub topology is using
Q69: When configuring Control Plane Policing on a
Q70: An engineer configured two routers connected to
Q71: An engineer configured SNMP notifications sent to