Multiple Choice
An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of 10.10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format that provides an adequate amount of addresses on the network. What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?
A) Update the IP addresses from IPv4 to IPv6 without deleting from Cisco FMC.
B) Format and reregister the device to Cisco FMC.
C) Cisco FMC does not support devices that use IPv4 IP addresses.
D) Delete and reregister the device to Cisco FMC.
Correct Answer:
Verified
Correct Answer:
Verified
Q22: Which command is run at the CLI
Q23: A network engineer is configuring URL Filtering
Q24: When creating a report template, how are
Q25: Which two packet captures does the FTD
Q26: Which protocol establishes network redundancy in a
Q28: An engineer is troubleshooting application failures through
Q29: An engineer is building a new access
Q30: Which two dynamic routing protocols are supported
Q31: Which command should be used on the
Q32: An engineer is investigating connectivity problems on