Multiple Choice
Refer to the exhibit. 
A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?
A) The port-channel mode should be set to auto.
B) The port channel on SW2 is using an incompatible protocol.
C) The port-channel trunk is not allowing the native VLAN.
D) The port-channel interface load balance should be set to src-mac.
Correct Answer:
Verified
Correct Answer:
Verified
Q119: Which two statements about VRF-Lite are true?
Q120: Which two entities are Type 1 hypervisors?
Q121: A client with IP address 209.165.201.25 must
Q122: Where is radio resource management performed in
Q123: Which requirement for an Ansible-managed node is
Q125: <img src="https://d2lvgg3v3hfg70.cloudfront.net/C1178/.jpg" alt=" Refer to the
Q126: Refer to the exhibit. <img src="https://d2lvgg3v3hfg70.cloudfront.net/C1178/.jpg" alt="Refer
Q127: Refer to the exhibit. <img src="https://d2lvgg3v3hfg70.cloudfront.net/C1178/.jpg" alt="Refer
Q128: Which two statements about single-hub DMVPN are
Q129: Which antenna type should be used for