Multiple Choice
Fasteners may have to be measured by a ruler or ______ caliper to identify their designation.
A) Vernier
B) Angled
C) Polished
D) None of the answers listed
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q96: A torque wrench is also known as
Q97: Technicians have a selection of their own
Q98: A steel hammer might mark or damage
Q99: Technician A states that a Vernier caliper
Q100: A(n) _ narrows at the tip, which
Q102: Which of the following is a type
Q103: Tech A says that gaskets can be
Q104: Tech A says that lockout is designed
Q105: Dial indicators normally have either _ indicator
Q106: To use a dial bore gauge, select