Multiple Choice
When a cylinder head bolt torque specification requires that the fastener is first torqued, then turned through a further set number of degrees, the method is known as:
A) template torque
B) twist torque
C) constant clamping force
D) bolt tensioning
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q1: If a single slab cylinder head is
Q2: Which of the following liner types would
Q3: When a hone is used to glaze-bust
Q5: What would be a typical clearance specification
Q6: Technician A says that cylinder block torque
Q7: What should be used to check valve
Q8: Which of the following is NOT usually
Q9: Where does cavitation erosion normally occur on
Q10: Which of the following components would NOT
Q11: What is wet liner cavitation caused by?<br>A)