Multiple Choice
What is the only way an engineer can alter the value of the bridge ID?
A) Modify the main switch MAC address
B) Configure the bridge ID under STP configuration mode
C) Swap out the main switch network interface card
D) Configure the STP priority
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q10: What is the difference between EtherChannel auto
Q11: Which command lets an engineer set the
Q12: Rather than adopting Cisco's proprietary STP method,
Q13: Which command on a Cisco Catalyst switch
Q14: Which EtherChannel mode should be used if
Q15: When configuring a switch with system ID
Q17: An engineer wants to define the load
Q18: An engineer would like to define the
Q19: When configuring an EtherChannel manually, how many
Q20: Which of the following sends one set