Multiple Choice
An engineer would like to define the load distribution method as both the source and destination IP addresses. Which command should this engineer use?
A) port-channel load-balance src-dst-mac
B) port-channel load-balance dst-port
C) port-channel load-balance src-dst-ip
D) port-channel load-balance dst-ip-src
Correct Answer:
Verified
Correct Answer:
Verified
Q1: Which STP mode is the default on
Q2: An engineer needs to define the load
Q3: When transmitting messages on VLAN trunks, which
Q4: Which command lets an engineer set the
Q6: What are the two different EtherChannel protocols
Q7: Which two standards are supported by most
Q8: Which Cisco STP mode extends on the
Q9: Which of the following terms is not
Q10: What is the difference between EtherChannel auto
Q11: Which command lets an engineer set the