True/False
When robots are moved during programming by using the tool mode, the movement follows the universal robot coordinate system.
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q1: Match the LAN component t o its
Q2: Match the robot term with its definition
Q3: This geometry is also called polar arm
Q4: Most likely gripper to use for a
Q5: Which of the following is not a
Q7: The most commonly used axis position feedback
Q8: The second most popular geometry for pneumatic
Q9: Determinism as applied to ControlNet is the
Q10: Star topologies are relatively expensive to install
Q11: Because of its small diameter, _ does