Multiple Choice
Most likely gripper to use for parts with a hole in the center and a finish that must not be scratched.
A) Vacuum grippers
B) Finger and bellows grippers
C) Pin and mandrel grippers
D) Parallel and angular grippres
E) All of the above
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q100: Work cell control software usually consists of
Q101: The geometry where the repeatability is better
Q102: Continuous -path program control is used where
Q103: The most important rule to avoid injury
Q104: Match the DeviceNet messaging type t o
Q106: Match the DeviceNet messaging type t o
Q107: The type of gripper that would use
Q108: Poor shield connection is a large problem
Q109: When troubleshooting problems in a new production
Q110: In fiber optic cables, mulitmode fibers are