Multiple Choice
The cylinder head bolts should be tightened (torqued) by which of these sequences?
A) Starting at the front of the engine and torqueing bolts from front to rear
B) Four outside bolts first, then from the center out
C) From the outside bolts to the inside bolts
D) From the inside bolts to the outside bolts
Correct Answer:
Verified
Correct Answer:
Verified
Q23: Service information states SAE 30 engine oil
Q24: The most common cause of premature bearing
Q25: Two technicians are discussing the torqueing procedure
Q26: Technician A says that studs should be
Q27: An engine dynamometer may use devices to
Q28: If the torque and horsepower readings are
Q30: Engine pre-oiling is recommended for which of
Q31: Technician A says that the back of
Q32: A coating often used to keep an
Q33: An engine block is being fitted with