Multiple Choice
Cylinder taper and out of round should be measured ________.
A) Near the bottom of piston travel
B) Just below the ridge
C) Both A and B
D) Neither A nor B
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q18: The threaded movable part that rotates on
Q19: Which tool is best to measure valve
Q20: A telescopic gauge can be used to
Q21: What is the reading on this inch
Q22: Which measuring gauge needs to be set
Q24: What is the reading on this metric
Q25: On pushrod engines, camshaft journal diameter often
Q26: A dial indicator may be mounted by
Q27: To check a crankshaft journal for out-of-round,
Q28: Which of the following cannot be measured