Table 6.1
Factors for Calculating Three-Sigma Limits for the

\bar { X }

-chart and R-chart

\begin{array} { | c | c | c | c | } \hline \begin{array} { c } \text { Size of } \\\text { Sample } \\( n )\end{array} & \begin{array} { c } \text { Factor for UCL } \\\text { and LCL for } X \text { - } \\\text { Charts } \\\left( A _ { 2 } \right)\end{array} & \begin{array} { c } \text { Factor for } \\\text { LCL for } R \text { - } \\\text { Charts } \\\left( D _ { 2 } \right)\end{array} & \begin{array} { c } \text { Factor for } \\\text { UCL for } R \text { - } \\\text { Charts } \\\left( D _ { 1 } \right)\end{array} \\\hline 2 & 1.880 & 0 & 3.267 \\3 & 1.023 & 0 & 2.575 \\4 & 0.729 & 0 & 2.282 \\5 & 0.577 & 0 & 2.115 \\6 & 0.483 & 0 & 2.004 \\7 & 0.419 & 0.076 & 1.924 \\8 & 0.373 & 0.136 & 1.864 \\9 & 0.397 & 0.184 & 1.816 \\10 & 0.308 & 0.233 & 1.777 \\\hline\end{array}

Source: 1950 Manual on Quality Control of Materials, copyright
American Society for Testing Materials. Reprinted with permission.
-A milling operation has historically produced an average thickness of 0.005 inch with an average range of 0.015 inch.Currently,the first three items from each batch of 20 are inspected.Use Table 6.1.What is the value of the LCL

\bar { X }

?
A) less than or equal to 0.00100
B) greater than 0.00100 but less than or equal to 0.00299
C) greater than 0.00299 but less than or equal to 0.00499
D) greater than 0.00499

The Idea of Continuous Improvement Is That Activities Not Contributing

Multiple Choice

Correct Answer:VerifiedUnlock this answer nowGet Access to more Verified Answers free of chargeAccess For Free

Correct Answer:
Verified
Unlock this answer now
Get Access to more Verified Answers free of charge