Question 1

The RJ-48 connector is commonly used with what type of network connections?

Accepted Answer

A) Ethernet 
B) Satellite 
C) Cable 
D) T1 lines 
A) Ethernet 
B) Satellite 
C) Cable 
D) T1 lines D

Question 2

"Another term for network congestion" defines which of the following?

Accepted Answer

A) Bottled 
B) Bottlenecking 
C) Constricted 
D) Constricting 
E) None of these answers are correct. 
A) Bottled 
B) Bottlenecking 
C) Constricted 
D) Constricting 
E) None of these answers are correct. B

Question 3

The main cross-connect (MC)connects to which of the following? (Choose two.)

Accepted Answer

A) Telco 
B) ISP 
C) Floor distributors 
D) Work station outlet 
A) Telco 
B) ISP 
C) Floor distributors 
D) Work station outlet A, B

Question 4

What are two types of punch-down blocks that might be found in an older system within the telecommunications closet? (Choose two.)

Accepted Answer

A) 66 block 
B) 100 block 
C) 110 block 
D) 200 block 
A) 66 block 
B) 100 block 
C) 110 block 
D) 200 block

Question 5

"Interconnected LANs within a limited geographic area" defines which of the following?

Accepted Answer

A) Campus Network 
B) Wide Area Network 
C) Metropolitan Area Network 
D) None of these answers are correct. 
A) Campus Network 
B) Wide Area Network 
C) Metropolitan Area Network 
D) None of these answers are correct.

Question 6

"Where the cable connects to a jack or a patch panel" defines which of the following?

Accepted Answer

A) TCO 
B) Closet 
C) Termination 
D) None of these answers are correct. 
A) TCO 
B) Closet 
C) Termination 
D) None of these answers are correct.

Question 7

The nominal velocity of propagation for UTP

Accepted Answer

A) Should be close to 1 
B) Should be close to 100m 
C) Is the speed of light 
D) Should be some percentage of the speed of light 
A) Should be close to 1 
B) Should be close to 100m 
C) Is the speed of light 
D) Should be some percentage of the speed of light

Question 8

The proper alignment of the transmit and receive pairs in a CAT5/5e/6 UTP cable requires what?

Accepted Answer

A) The transmit (+)and (-)signals connected to the receivers (+)and (-)signals, respectively. 
B) The transmit (+)and (-)signals connected to the receivers (-)and (+)signals, respectively. 
C) The transmit (-)and (+)signals connected to the receivers (-)and (+)signals, respectively. 
D) None of these answers are correct. 
A) The transmit (+)and (-)signals connected to the receivers (+)and (-)signals, respectively. 
B) The transmit (+)and (-)signals connected to the receivers (-)and (+)signals, respectively. 
C) The transmit (-)and (+)signals connected to the receivers (-)and (+)signals, respectively. 
D) None of these answers are correct.

Question 9

"Consists of all the link elements from the wall plate to the switch" defines which of the following?

Accepted Answer

A) Complete Link 
B) Full Channel 
C) Full Link 
D) Link 
E) None of these answers are correct. 
A) Complete Link 
B) Full Channel 
C) Full Link 
D) Link 
E) None of these answers are correct.

Question 10

What are two potential problems if you create a split pair connection when you are working with a straight-through patch cable? (Choose two.)

Accepted Answer

A) Interference 
B) Attenuation 
C) Crosstalk 
D) Short 
A) Interference 
B) Attenuation 
C) Crosstalk 
D) Short

Question 11

"A graphical or text description of the wire connections from pin to pin" defines which of the following?

Accepted Answer

A) Color-map 
B) Continuity map 
C) Wire-map 
D) Connectivity map 
E) None of these answers are correct. 
A) Color-map 
B) Continuity map 
C) Wire-map 
D) Connectivity map 
E) None of these answers are correct.

Question 12

RG-6 and RG-59 cables are used in what type of systems? (Choose two.)

Accepted Answer

A) Satellite 
B) Cable television 
C) DSL 
D) Fiber 
A) Satellite 
B) Cable television 
C) DSL 
D) Fiber

Question 13

"An Ethernet system operating at 100Mbps" defines which of the following?

Accepted Answer

A) AUI Ethernet 
B) Link Ethernet 
C) Gigabit Ethernet 
D) Fast Ethernet 
E) None of these answers are correct. 
A) AUI Ethernet 
B) Link Ethernet 
C) Gigabit Ethernet 
D) Fast Ethernet 
E) None of these answers are correct.

Question 14

What type of terminations are found with RG-6 and RG-59 cables? (Choose two.)

Accepted Answer

A) G-type 
B) RJ-10 
C) F-type 
D) BNC 
A) G-type 
B) RJ-10 
C) F-type 
D) BNC

Question 15

What is another name for an RJ-45 connector?

Accepted Answer

A) 8C8P 
B) 8W8T 
C) 8P8C 
D) 8P8T 
A) 8C8P 
B) 8W8T 
C) 8P8C 
D) 8P8T

Question 16

CAT 6 UTP is recommended for use in what? (Select all that apply.)

Accepted Answer

A) The campus network backbone cabling 
B) Only the equipment room 
C) The horizontal cabling for a LAN 
D) Is not recommended in LANs 
E) The work area 
A) The campus network backbone cabling 
B) Only the equipment room 
C) The horizontal cabling for a LAN 
D) Is not recommended in LANs 
E) The work area

Question 17

The RJ-48 connector uses what type of cabling?

Accepted Answer

A) Twisted pair 
B) Wireless 
C) MMF 
D) SMF 
A) Twisted pair 
B) Wireless 
C) MMF 
D) SMF

Question 18

In the balanced mode of operation for UTP

Accepted Answer

A) The (+)side connects to ground. 
B) The (-)side connects to ground. 
C) Neither wire in the wire pairs connects to ground. 
D) The balanced mode of operation for UTP is only used with STP cable installations. 
E) The balanced mode of operation for UTP is only used in high EMI environments. 
A) The (+)side connects to ground. 
B) The (-)side connects to ground. 
C) Neither wire in the wire pairs connects to ground. 
D) The balanced mode of operation for UTP is only used with STP cable installations. 
E) The balanced mode of operation for UTP is only used in high EMI environments.

The RJ-48 connector is commonly used with what type of network connections?

"Another term for network congestion" defines which of the following?

The main cross-connect (MC)connects to which of the following? (Choose two.)

What are two types of punch-down blocks that might be found in an older system within the telecommunications closet? (Choose two.)

"Interconnected LANs within a limited geographic area" defines which of the following?

"Where the cable connects to a jack or a patch panel" defines which of the following?

The nominal velocity of propagation for UTP

The proper alignment of the transmit and receive pairs in a CAT5/5e/6 UTP cable requires what?

"Consists of all the link elements from the wall plate to the switch" defines which of the following?

What are two potential problems if you create a split pair connection when you are working with a straight-through patch cable? (Choose two.)

"A graphical or text description of the wire connections from pin to pin" defines which of the following?

RG-6 and RG-59 cables are used in what type of systems? (Choose two.)

"An Ethernet system operating at 100Mbps" defines which of the following?

What type of terminations are found with RG-6 and RG-59 cables? (Choose two.)

What is another name for an RJ-45 connector?

CAT 6 UTP is recommended for use in what? (Select all that apply.)

The RJ-48 connector uses what type of cabling?

In the balanced mode of operation for UTP

Introduction to Computer Networks

Physical Layer Cabling: Fiber Optics

Wireless Networking

Interconnecting the Lans

Tcp/Ip

Introduction to Router Configuration

Introduction to Switch Configuration

Routing Protocols

Internet Technologies: Out to the Internet

Troubleshooting

Network Security

Cloud Computing and Virtualization

Codes and Standards

Filters

Exam 2: Physical Layer Cabling: Twisted Pair

The RJ-48 connector is commonly used with what type of network connections?

"Another term for network congestion" defines which of the following?

The main cross-connect (MC)connects to which of the following? (Choose two.)

What are two types of punch-down blocks that might be found in an older system within the telecommunications closet? (Choose two.)

"Interconnected LANs within a limited geographic area" defines which of the following?

"Where the cable connects to a jack or a patch panel" defines which of the following?

The nominal velocity of propagation for UTP

The proper alignment of the transmit and receive pairs in a CAT5/5e/6 UTP cable requires what?

"Consists of all the link elements from the wall plate to the switch" defines which of the following?

What are two potential problems if you create a split pair connection when you are working with a straight-through patch cable? (Choose two.)

"A graphical or text description of the wire connections from pin to pin" defines which of the following?

RG-6 and RG-59 cables are used in what type of systems? (Choose two.)

"An Ethernet system operating at 100Mbps" defines which of the following?

What type of terminations are found with RG-6 and RG-59 cables? (Choose two.)

What is another name for an RJ-45 connector?

CAT 6 UTP is recommended for use in what? (Select all that apply.)

The RJ-48 connector uses what type of cabling?

In the balanced mode of operation for UTP

Introduction to Computer Networks

Physical Layer Cabling: Fiber Optics

Wireless Networking

Interconnecting the Lans

Tcp/Ip

Introduction to Router Configuration

Introduction to Switch Configuration

Routing Protocols

Internet Technologies: Out to the Internet

Troubleshooting

Network Security

Cloud Computing and Virtualization

Codes and Standards

Filters