Exam 16: Reassembly and Starting

An engine failed because it was overheated. Technician A says that a coolant temperature sensor could be defective. Technician B says that the fan relay could be defective. Who is right?

(Multiple Choice)

4.9/5

(25)

Question 41

An OHC cylinder head is being installed on an engine. Technician A says that some OHC cylinder heads cannot be installed if the camshaft is not positioned correctly at TDC. Technician B says that valves can be bent if the correct procedures are not followed. Who is right?

(Multiple Choice)

4.9/5

(30)

Question 42

The first oil change on a rebuilt engine should be performed at _____ miles.

(Short Answer)

4.9/5

(37)

Question 43

Technician A says valve lash can be set on some engines when it is running. Technician B says to break in the rings, on the highway accelerate to 50 mph and coast back to 35 mph at least 10 times. Who is right?

(Multiple Choice)

4.8/5

(31)

Question 44

Which of the following is/are true about rebuilt engine warranties?

(Multiple Choice)

4.7/5

(33)

Question 45

Showing 41 - 45 of 45

An engine failed because it was overheated. Technician A says that a coolant temperature sensor could be defective. Technician B says that the fan relay could be defective. Who is right?

An OHC cylinder head is being installed on an engine. Technician A says that some OHC cylinder heads cannot be installed if the camshaft is not positioned correctly at TDC. Technician B says that valves can be bent if the correct procedures are not followed. Who is right?

The first oil change on a rebuilt engine should be performed at _____ miles.

Technician A says valve lash can be set on some engines when it is running. Technician B says to break in the rings, on the highway accelerate to 50 mph and coast back to 35 mph at least 10 times. Who is right?

Which of the following is/are true about rebuilt engine warranties?

Engine Operation

Engine Shop Safety

Diagnosing Engine Problems

Engine Removal, Disassembly, Inspection, and In-Chassis Repairs

Cleaning the Engine

Micrometer Practice

Cylinder Head: Parts and Service

Cylinder Head: Springs, Valves, and Valve Sets

Camshafts, Lifters, Timing Belts, and Chains

Cylinder Block: Inspection and Service

Crankshaft, Bearings, and Engine Balancing

Pistons, Rings, and Connecting Rods

Lubrication

Cooling System

Engine Hardware: Fasteners, Thread Repair, and Gaskets

Engine Breathing: Intake and Exhaust Systems

Turbochargers and Superchargers

Producing Power: Valve Timing, Power and Torque Measurement

Filters