Exam 13: Switching Circuit Installation
Exam 1: Residential Workplace Safety47 Questions
Exam 2: Hardware and Materials Used in Residential Wiring53 Questions
Exam 3: Tools Used in Residential Wiring46 Questions
Exam 4: Test and Measurement Instruments Used in Residential Wiring51 Questions
Exam 5: Understanding Residential Building Plans41 Questions
Exam 6: Determining Branch Circuit, Feeder Circuit, and Service Entrance Requirements49 Questions
Exam 7: Introduction to Residential Service Entrances48 Questions
Exam 8: Service Entrance Equipment and Installation42 Questions
Exam 9: General Nec Requirements for Rough-In Wiring49 Questions
Exam 10: Electrical Box Installation44 Questions
Exam 11: Cable Installation49 Questions
Exam 12: Raceway Installation47 Questions
Exam 13: Switching Circuit Installation44 Questions
Exam 14: Branch-Circuit Installation47 Questions
Exam 15: Special Residential Wiring Situations49 Questions
Exam 16: Video, Voice, and Data Wiring Installation52 Questions
Exam 17: Lighting Fixture Installation52 Questions
Exam 18: Device Installation46 Questions
Exam 19: Service Panel Trim-Out42 Questions
Exam 20: Checking Out and Troubleshooting Electrical Wiring Systems41 Questions
Exam 21: Green Wiring Practices32 Questions
Exam 22: Photovoltaic Pv System Installation44 Questions
Select questions type
Four-way switches must be wired __________ in a switching circuit that has more than two switching locations.
(Multiple Choice)
4.8/5
(35)
If the circuit-equipment grounding conductor is connected to the green grounding terminal on a switch, there is no need to ground the metal device box in which the switch is installed.
(True/False)
4.8/5
(38)
Describe benefits to using timers, motion sensors, and occupancy sensors in residential electrical systems.
(Essay)
4.8/5
(38)
Explain how a switch loop for a single-pole switch following the requirements of Section 404.2(C) is wired.Assume the use of Type NM cable.
(Essay)
4.9/5
(36)
Showing 41 - 44 of 44
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)