Exam 10: Working Drawings--Upper Level
Exam 1: Commercial Building Plans and Specifications20 Questions
Exam 2: Reading Electrical Working Drawings--Entry Level20 Questions
Exam 3: General Requirements for Conductors16 Questions
Exam 4: Branch Circuits20 Questions
Exam 5: Switches and Receptacles20 Questions
Exam 6: Wiring Methods20 Questions
Exam 7: Motor and Appliance Circuits20 Questions
Exam 8: Feeder Installation and Load Calculation22 Questions
Exam 9: Special Systems20 Questions
Exam 10: Working Drawings--Upper Level20 Questions
Exam 11: Special Circuits Owners Circuits20 Questions
Exam 12: Panelboard Selection and Installation20 Questions
Exam 13: The Electric Service and Grounding20 Questions
Exam 14: Lamps and Ballasts for Lighting20 Questions
Exam 15: Luminaires20 Questions
Exam 16: Emergency, Legally Required Standby, and Optional Standby Power Systems20 Questions
Exam 17: Overcurrent Protection: Fuses and Circuit Breakers20 Questions
Exam 18: Short-Circuit Calculations and Coordination of Overcurrent Protective Devices20 Questions
Exam 19: Equipment and Conductor Short-Circuit17 Questions
Exam 20: Low-Voltage Remote Control20 Questions
Exam 21: The Cooling System20 Questions
Exam 22: Commercial Utility-Interactive Photovoltaic Systems20 Questions
Select questions type
When tabulating materials, take special note of long runs of raceway or cable and determine whether ____ is a problem. This can mean an increase in conductor and/or raceway size.
Free
(Multiple Choice)
4.7/5
(31)
Correct Answer:
C
The ____ feature of a receptacle provides protection from lightning and other severe electrical surges that may occur in the electrical system.
Free
(Multiple Choice)
4.8/5
(36)
Correct Answer:
A
In the computer room example in this chapter, the grounding terminal of each of the special receptacles is connected to a(n)____.
Free
(Multiple Choice)
4.7/5
(33)
Correct Answer:
A
What steps should you take while tabulating materials to ensure the best possible outcome?
(Essay)
5.0/5
(34)
According to NEC 422.31(B), having a disconnect switch in sight is required if a(n)____ is not readily accessible.
(Multiple Choice)
4.8/5
(40)
A washer-dryer is rated for 4000 VA at 208Y/120 volts single-phase. The overcurrent protective device must be rated at least ____ amperes.
(Multiple Choice)
4.9/5
(35)
In the insurance office example in this chapter, a special raceway is installed in the ____. This raceway provides for both electrical power and communications.
(Multiple Choice)
4.8/5
(30)
In the insurance office example in this chapter, a separate, insulated-grounding conductor is installed with the feeder circuit and is connected to the neutral conductor at the service. This grounding system reduces, if not eliminates, the ____ that often is (are)present in the conventional grounding system.
(Multiple Choice)
4.9/5
(43)
NEC 422.13 requires that the branch circuit overcurrent device and conductors for a storage-type electric water heater with a capacity of 120 gallons (450 L)or less must be sized at not less than ____ percent of the rating of the water heater .
(Multiple Choice)
4.7/5
(40)
What steps have been taken to make the computer room example in this chapter compliant with good practice?
(Essay)
4.8/5
(39)
____ are available in separate units, which can be used to provide protection on any type of sensitive equipment, such as computers and printers .
(Multiple Choice)
4.8/5
(32)
A washer-dryer rated for 4000 VA at 208Y/120 volts single-phase must have a branch-circuit ampacity of at least ____ amperes.
(Multiple Choice)
4.9/5
(36)
In the water heater circuit example in this chapter, the minimum size conductor, if all terminals are rated 75 degrees Celsius or higher, is ____ AWG as the ampacity in NEC Table 310.16 is 85 amperes.
(Multiple Choice)
4.9/5
(29)
In the insurance office example in this chapter, the reception area has a(n)____ to provide a different "look" for the clients.
(Multiple Choice)
4.8/5
(28)
In the computer room circuits in the chapter example, three separate neutral conductors are installed to reduce the possibility of a conductor overheating from ____ currents.
(Multiple Choice)
4.8/5
(44)
In the water heater installation example in this chapter, what is the meaning of temperature limiting?
(Essay)
4.8/5
(30)
Water heaters are available for commercial occupancies in many sizes and voltages, and for both single and ____ supply.
(Multiple Choice)
4.7/5
(43)
Describe basic water heater specifications and those of the beauty salon example in this chapter, and explain the role the electrical contractor in this area.
(Essay)
4.8/5
(37)
Three-phase circuits result in a smaller ____ than if a 1-phase circuit were installed.
(Multiple Choice)
4.9/5
(31)
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)