Exam 7: Introduction to Router Configuration

The values for configuring a serial connection to connect to a Cisco router's console port are: 5600bps 8 data bits No parity 1 stop bit Hardware flow control True or False?

The sh ip int brief command shows that the protocol for Ethernet0 is "down" and the status is up.This indicates which of the following?

The sequence of commands for setting the enable secret to Chile is: router> enable router# enable secret Chile True or False?

The AUI port on a router connects to which networking protocol?

The router commands used to configure and enable the FastEthernet 0/1 router interface with the IP address of 10.10.20.250 and a subnet mask of 255.255.0.0 are: Router# conf t Router(config)# int fa0/1 Router(config-if)# ip address 10.10.20.250 255.255.0.0 Router(config-if)# no shut True or False?

The DCE end of a V.35 cable is female.True or False?

The command line vty 0 4 means: line places the router in the line configuration mode vty: virtual terminal 0 4: indicates virtual terminal connections can be simultaneously configured True or False?

The designation s0/0 indicates which of the following?

The prompt for a router's user EXEC mode is router/ >.True or False?

AUI stands for which of the following?