Multiple Choice
Technician A says when glaze breaking a cylinder, you must go from the very top to the very bottom of the cylinder to achieve desired results. Technician B says a drill motor with a speed of 450 rpm works well for deglazing a cylinder. Who is correct?
A) Technician A
B) Technician B
C) Both technicians
D) Neither technician
Correct Answer:
Verified
Correct Answer:
Verified
Q34: Where would NPT threads be found on
Q35: Technician A says that removing 0.015" of
Q36: What can be put on the outside
Q37: After glaze breaking or cylinder honing, clean
Q38: Technician A says that a main bearing
Q39: After hot-tanking and rinsing a block, what
Q40: When plateau honing a cylinder, a _-grit
Q42: Technician A says that if the camshaft
Q43: What is the name for the 20°
Q44: All of the following are used for