Short Answer
What is the name for the 20° to 60° crisscross pattern left during cylinder wall honing?
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q34: Where would NPT threads be found on
Q35: Technician A says that removing 0.015" of
Q36: What can be put on the outside
Q37: After glaze breaking or cylinder honing, clean
Q38: Technician A says that a main bearing
Q39: After hot-tanking and rinsing a block, what
Q40: When plateau honing a cylinder, a _-grit
Q41: Technician A says when glaze breaking a
Q42: Technician A says that if the camshaft
Q44: All of the following are used for