Exam 6: Fundamentals of Electronics and Computers

Which of the following is the most recent truck data bus system?

Approximately how much voltage is required to forward bias a bipolar transistor?

When a diode allows current to flow through it,what state is it in?

What is hertz used to measure?

Which terminal of a transistor is the output terminal?

When PROM and EEPROM data retention are combined in a card or set of chips,what is this called by some OEMs?

Which type of thermistor would most likely be used as an input to a truck's computer circuit?

What would be required of a two-switch AND gate to produce an output?

Which terminal of a transistor can be regarded as the "switch"?

Which of the following numbers would be equivalent to the binary coded number 0000 1000?

Where in a chassis electronic system is the master program for system management usually located?

What component in a computer controlled chassis system manages V-Ref (reference voltage)?

Which of the following types of input circuit sensor does not require V-Ref?

Which of the following input sensors could be used to signal pressure values?

Which of the following computer memory categories is volatile?

Which of the following electrical devices is often used to measure temperature?

What is used in a truck system ECM or ECU to switch output circuit devices?

Which of the following materials is defined as a semiconductor?

What is the term we use in truck electronics to describe what happens when two or more chassis computers are connected "talk" to each other?

How many terminals are there on a diode?