Exam 22: Electrical System Operation and Service
Exam 1: Collision Repair: Introduction and Careers40 Questions
Exam 2: Shop Safety40 Questions
Exam 3: Vehicle Construction Technology38 Questions
Exam 4: Service Information, Specifications, and Measurements 37 Questions
Exam 5: Hand Tools40 Questions
Exam 6: Power Tools and Equipment37 Questions
Exam 7: Compressed Air System Technology40 Questions
Exam 8: Collision Repair Materials and Fasteners41 Questions
Exam 9: Outer Body Panel Service39 Questions
Exam 10: Door, Roof, and Moveable Glass Service39 Questions
Exam 11: Repairing Sheet Metal43 Questions
Exam 12: Using Body Fillers40 Questions
Exam 13: Plastic Repair37 Questions
Exam 14: Passenger Compartment Service40 Questions
Exam 15: Welding Technology39 Questions
Exam 16: Structural Glass Service40 Questions
Exam 17: Bodyframe Damage Measurement39 Questions
Exam 18: Unibodyframe Repair and Realignment37 Questions
Exam 19: Welded Panel Replacement37 Questions
Exam 20: Restoring Corrosion Protection37 Questions
Exam 21: Chassis Service and Wheel Alignment47 Questions
Exam 22: Electrical System Operation and Service49 Questions
Exam 23: Restraint System Operation46 Questions
Exam 24: Hybrid and Electric Vehicle Service37 Questions
Exam 25: Damage Analysis and Estimating Service40 Questions
Exam 26: Refinishing Equipment39 Questions
Exam 27: Surface Preparation and Masking35 Questions
Exam 28: Refinishing Procedures38 Questions
Exam 29: Color Matching and Custom Painting37 Questions
Exam 30: Paint Problems and Final Detailing42 Questions
Select questions type
____________________ is a mathematical formula for calculating an unknown electrical value (amps, volts, or ohms) when two values are known.
(Essay)
4.7/5
(39)
With a(n) ____, the shorted wire only touches ground and shorts momentarily when the vehicle bounces heavily or is jarred.
(Multiple Choice)
5.0/5
(35)
____ is the movement of electricity (electrons) through a wire or circuit.
(Multiple Choice)
4.9/5
(31)
A ____ has a large electric motor that turns the engine flywheel.
(Multiple Choice)
4.8/5
(42)
A(n) ____________________ is used to turn a circuit on or off manually (by hand).
(Essay)
4.8/5
(36)
_________________________ are used to temporarily bypass circuits or components for testing.
(Essay)
4.8/5
(43)
A dead short to ground is usually a bare conductor touching directly against the vehicle frame.
(True/False)
4.8/5
(40)
Whenever a technician has an electrical system problem that directly concerns the computer, a testlight is handy.
(True/False)
4.9/5
(36)
A(n) ____ is disconnected and does not have a complete electrical path.
(Multiple Choice)
4.8/5
(42)
While having a discussion, Technician A says that a high input failure results when the signal reaching the on-board computer has more voltage, more current, or a higher frequency than normal.Technician B says that this is often caused by failure of a sensor or a mechanical fault.Who is correct?
(Multiple Choice)
4.9/5
(38)
A(n) _________________________ is designed to shut the electric fuel pump off after a collision.
(Essay)
4.9/5
(40)
Fuses burn in half with excess current to protect a circuit from further damage.
(True/False)
4.9/5
(44)
According to Honda's service information, the side-view mirror camera must be recalibrated anytime when one of the following procedures is performed EXCEPT:
(Multiple Choice)
4.8/5
(31)
A ____ holds the various circuit fuses, breakers, and sometimes the flasher units for the turn and emergency lights.
(Multiple Choice)
4.8/5
(43)
Blind spots are areas in front of and behind the vehicle that cannot be seen by the driver.
(True/False)
4.7/5
(41)
Technician A say that adaptive cruise control uses radar (radio detection and ranging) as range detection sensors.Technician B says Lidar uses radio waves that allows the system to construct a 3D image.Who is right?
(Multiple Choice)
4.8/5
(45)
All of the following are components of a circuit breaker EXCEPT:
(Multiple Choice)
4.9/5
(35)
Showing 21 - 40 of 49
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)