Exam 9: Outer Body Panel Service

How would you perform a trunk lid adjustment?

New vehicle bumpers are designed to withstand major impact without damage.

Hood adjustments are made at the hinges,at the adjustable stops, and at the hood latch.

Fenders are bolted to all of the following EXCEPT:

Truck beds normally mount to _______?

A ____ is a thin, U-shaped piece of metal for making part adjustments.

How would you remove a hood latch?

All of the following are components of a front bumper EXCEPT:

____ are used to cushion some of the impact of a collision and reduce damage.

Hood hinge adjustments control the general position of the hood in relation to the fenders and the rear hood height.

A(n) ____ or power knife has a thin blade that will cut through the adhesive without causing part damage.

____ are often bonded to the inside surface of trunk cavities and doors to reduce noise,vibration, and harshness.

Which of the following is LEAST-Likely a part that must be serviced when replacing a rear hatch lid?

A(n) ____ is handy for reaching down and unscrewing grille bolts.

How would you cut off an old molding?

____ improve aerodynamics by restricting air passing under the vehicle body, thus reducing turbulence and resistance to airflow.

A common mistake during hood removal is forgetting to disconnect windshield washer hoses and wires, which can break or snap small hose fittings or sever wires.

The term MOST-Likely used to describe the distance measure between two adjacent parts, such as hood-to-fender gap is:

During collision repair, ____ must be replaced to match preaccident performance.