Exam 7: Compressed Air System Technology

The ____________________ compressor uses a flexible synthetic rubber membrane to produce a pumping action.

Compressors indicate regulated air pressure and, in some cases, main line pressure as well.

A ____ is a type of connection that is male on both ends.

____ are provided for filling and changing air pump oil.

The ______________________________ pump develops compressed air pressure through the action of a reciprocating piston.

A(n) ____ is a type of connection that is male on one end and female on the other.

What are the typical components of a stationary compressor?

What is the purpose of an air pressure regulator?

A(n) ____ is used to reduce the temperature of compressed air.

Piston compressor pumps are available in single or multiple cylinder and single- or two-stage models.

All of the following are components of a typical two-stage compressor EXCEPT:

While having a discussion, Technician A says that an air hose should always be used for solvent-based paints.Technician B says that solvents can corrode the hose material and cause hole failure and rupture as well as paint problems.Who is correct?

Which of the following is LEAST-Likely to be considered a type of air compressor?

The ______________________________ is designed to provide an adequate supply of clean, dry air at a predetermined pressure to ensure efficient operation of all pneumatic equipment in the body shop.

In a(n) ______________________________ air is first compressed to an intermediate pressure and then further compressed to a higher pressure.

When maintaining an air supply system, what precautions should you take before changing to a detergent type oil?

A(n) ____ is a hand valve that isolates the tank pressure from shop line pressure.

The intake air filter located on the compressor inlet is very important because all the air going into the compressor passes through this filter.

The ____ is designed to raise the pressure of air from normal atmospheric to some higher pressure.

An adapter is usually made up of an electric motor, air pump, and large air storage tank.