Exam 11: Count Control

The electromechanical counter requires a minimum of approximately ____ seconds OFF time between input impulses to reset.

The electromechanical control counter is similar to the electromechanical reset timer, except that the synchronous motor of the timer is replaced by a stepping motor. The stepping motor advances one step each time it is ____________________.

When line voltage is applied to the count ____________________, incoming count pulses are not counted.

In some counters, the output contacts can be adjusted to perform in a specific manner.

When the count motor has received the same number of count impulses as set on the dial, the contacts go the ____ condition.

When the stepping motor is deenergized, the contacts return to the reset condition.

A typical electromechanical counter is generally available with digital set and readout dials.

In a typical solid-state counter, three counting modes can be programmed: count directional, ____________________, and quadrature.

The solid-state counter uses CMOS (complimentary metal-oxide semiconductor) integrated circuits for the ___ function.