Exam 8: Introduction to Alternating Current and Voltage
Exam 1: Quantities and Units31 Questions
Exam 2: Voltage, Current, and Resistance69 Questions
Exam 3: Ohms Law, Energy, and Power64 Questions
Exam 4: Series Circuits64 Questions
Exam 5: Parallel Circuits62 Questions
Exam 6: Series-Parallel Circuits71 Questions
Exam 7: Magnetism and Electromagnetism66 Questions
Exam 8: Introduction to Alternating Current and Voltage66 Questions
Exam 9: Capacitors66 Questions
Exam 10: Rc Circuits65 Questions
Exam 11: Inductors62 Questions
Exam 12: Rl Circuits64 Questions
Exam 13: Rlc Circuits and Resonance68 Questions
Exam 14: Time Response of Reactive Circuits65 Questions
Exam 15: Transformers65 Questions
Exam 16: Regulators, Filters, and Op-Amps307 Questions
Exam 17: Understanding Transducers, Sensors, and Conversion in Industrial Processes80 Questions
Select questions type
-In Figure 8-1, the time from point C to E is called ________.

Free
(Multiple Choice)
4.8/5
(42)
Correct Answer:
D
In a two-resistor series circuit VR1=6.5 VRMS and VR2=3.2 VRMS. The source voltage is_____
Free
(Multiple Choice)
4.8/5
(33)
Correct Answer:
D
Superimposed DC and AC voltages mean the two voltages are combined:
(Multiple Choice)
4.8/5
(40)
Figure
-Calculate the total power dissipation in the circuit in Figure 8-2.

(Multiple Choice)
4.7/5
(31)
If a rectangular waveʹs pulse width is 50 μS and its frequency is 4 kHz, its duty cycle is ________.
(Multiple Choice)
4.8/5
(31)
The AC sine wave varies from zero to its maximum value in accordance with:
(Multiple Choice)
4.8/5
(31)
Troubleshooting an AC circuit can be performed with which of the following tools?
(Multiple Choice)
4.9/5
(27)
What is the instantaneous voltage at 284° on a 22 VPP sine wave?
(Multiple Choice)
4.9/5
(25)
An oscilloscope's seconds/division switch is set on 20 . If the trace is 7.5 cm long, what is the period?
(Multiple Choice)
4.8/5
(33)
-In Figure 8-1,W hich of the following can be measured from point E to point F?

(Multiple Choice)
4.8/5
(34)
While troubleshooting a circuit the voltage seems to be zero;What if any adjustment should be checked on the oscilloscope?
(Multiple Choice)
4.8/5
(32)
Showing 1 - 20 of 66
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)