Question 1

In a one view drawing, you could tell if a part is cylindrical because:

Accepted Answer

A) You can assume a part is cylindrical unless stated otherwise 
B) A centerline or diameter symbol would be shown 
C) Chamfers on the end of the part imply that it is round 
D) You would not be able to tell, so a second view is always required 
A) You can assume a part is cylindrical unless stated otherwise 
B) A centerline or diameter symbol would be shown 
C) Chamfers on the end of the part imply that it is round 
D) You would not be able to tell, so a second view is always required B

Question 2

For a gasket or shim, which of the following would most likely be specified by a note?

Accepted Answer

A) Hole radius 
B) Thickness 
C) Length 
D) Hole spacing 
A) Hole radius 
B) Thickness 
C) Length 
D) Hole spacing B

Question 3

Which of the following parts would NOT be suitable for a one-view drawing?

Accepted Answer

A) A rod 
B) A gasket 
C) A pin 
D) A pump housing 
A) A rod 
B) A gasket 
C) A pin 
D) A pump housing D

In a one view drawing, you could tell if a part is cylindrical because:

For a gasket or shim, which of the following would most likely be specified by a note?

Which of the following parts would NOT be suitable for a one-view drawing?

Industrial Drawings

Title Blocks

Lines and Symbols

Pictorial Sketching

Orthographic Projection

Three-View Drawings

Two-View Drawings

Auxiliary Views

Section Views

Dimensions and Tolerances

Decimal Dimensions and Tolerances

Dimensioning Holes, Keyways, and Keyseats

Dimensioning Arcs and Radii

Hole Patterns and Revision Blocks

Angles, Dovetails, and Slots

Metric Dimensions and Tolerances

Machining Symbols, Bosses, and Pads

Surface Texture

Tapers and Chamfers

Undercuts and Knurling

Screw Thread Specifications

Screw Thread Representation and Threaded Fasteners

Pipe Threads

Assembly Drawings

Welding Symbols

Geometric Tolerances - Datums

Geometric Tolerances - Location and Form

Filters

Exam 8: One-View Drawings

In a one view drawing, you could tell if a part is cylindrical because:

For a gasket or shim, which of the following would most likely be specified by a note?

Which of the following parts would NOT be suitable for a one-view drawing?

Industrial Drawings

Title Blocks

Lines and Symbols

Pictorial Sketching

Orthographic Projection

Three-View Drawings

Two-View Drawings

Auxiliary Views

Section Views

Dimensions and Tolerances

Decimal Dimensions and Tolerances

Dimensioning Holes, Keyways, and Keyseats

Dimensioning Arcs and Radii

Hole Patterns and Revision Blocks

Angles, Dovetails, and Slots

Metric Dimensions and Tolerances

Machining Symbols, Bosses, and Pads

Surface Texture

Tapers and Chamfers

Undercuts and Knurling

Screw Thread Specifications

Screw Thread Representation and Threaded Fasteners

Pipe Threads

Assembly Drawings

Welding Symbols

Geometric Tolerances - Datums

Geometric Tolerances - Location and Form

Filters