Exam 3: Basic Tools and Precision Measuring

Some tools are ________, so seek assistance if required, and use correct manual handling techniques when using tools.

______ are designed to cut soft metals.

Hand tools come in a variety of _____.

An automotive shop will usually have a selection of tools available for use, which includes:

An example of a tag-out would be affixing a(n) _________ to a piece of faulty equipment that describes the fault found in that equipment, includes the name of the person who found the fault, lists the date that the fault was found, and warns not to use the equipment.

A foot-pound is described as the amount of twisting force applied to a shaft by a perpendicular lever __________ placed on the outer end.

You should never use cleaning materials near an ______ or cigarette.

A power tool can be stationary, such as a(n) ______.

The full form of USCS is:

Technician A states that air tools should have oil added to their inlets once a month. Technician B states that air tools have no electrical motor built into them. Who is correct?

Automotive fasteners may have to be measured by a ruler or _______ to identify their designation.

A fault is found with a piece of diagnostic equipment. What needs to be done?

Technician A states that you should inspect tools prior to use to ensure they are in good working order. Technician B states that you should use tools to complete a task while ensuring manufacturer and shop procedures are followed. Who is correct?

________ are ideal for measuring valve guides on a cylinder head for wear.

Hand tools extend our ability to perform fundamental tasks such as:

The most common type of measuring tape found in shops is a thin metal strip about ____ wide.

_______ is an umbrella term that describes a set of safety practices and procedures that are intended to reduce the risk of technicians inadvertently using tools, equipment, or materials that have been determined to be unsafe, or potentially unsafe or that are in the process of being serviced.

A(n) ______ is capable of accurate measurements on shorter lengths, down to a millimeter or a fraction of an inch.

Technician A says the inside micrometer measures outside dimensions of an item. Technician B says the outside micrometer measures inside dimensions. Who is correct?

A ______ is a flexible type of ruler and is a common measuring tool.